Get correct communication with Cross 1

Get correct communication with Cross by RS232 Cable (Monochrome 100cm)

IMPORTANT: Please remember to change baudrate back to: 9600 after using RS232 communicating.  

RS232 Cable is just for Testing, often we use RF wireless communication. Our Latest Crossedit Software V6.2 can not change baudrate to avoid failure communication, and we will not send 232cable with cross again, if you need please contact me before order! 

 

1. This is the RS232 Cable, one port connect PC (notebook), another one plus in the Cross

 2. Now, we use our SH-100 green corss as a sample. 

3. This is our Notebook with RS232 Converter

4. Before we connect the Notebook with the Cross, please notcie to turn off the Cross! 

5. Control box and power supply of the green cross, the middle one is the port for the RS232 cable

6. Connect the RS232 with the Converter, and the Notebook

7. Then we open our cross edit software (below is a sample with our Spanish software)

   7.01Set Cross resolution and Baud rate. 80 Cross, 100 Cross and 120 Cross are,
   Resolution: 48 × 48 (pixel)
   Baud rate: 9600 (bps)

 7.02. Set Cross address(Search Cross)

    Each Cross is set and supplied with one exclusive ADDRESS. The address is an 8-digit code which is       composed of numbers (0~9) and capital letters (A~F). It is usually printed on a label sticked inside the   control box of Cross and on the label which is sticked on the outside package of Cross.

8. At this stage, if all the setting is correct, the software gets the correct communication and will say “Find cross!”

9. As soon as the software finds the Cross, user can already send messages to the Cross.